Baltimore–Washington Parkway

The Baltimore–Washington Parkway (also referred to as the B–W Parkway) is a controlled-access parkway in the U.S. state of Maryland, running southwest from Baltimore to Washington, D.C. The road begins at an interchange with U.S. Route 50 (US 50) near Cheverly in Prince George's County at the Washington, D.C. border, and continues northeast as a parkway maintained by the National Park Service (NPS) to MD 175 near Fort Meade, serving many federal institutions. This portion of the parkway is dedicated to Gladys Noon Spellman, a representative of Maryland's 5th congressional district, and has the unsigned Maryland Route 295 (MD 295) designation. Commercial vehicles, including trucks, are prohibited within this stretch. This section is administered by the NPS's Greenbelt Park unit. After leaving park service boundaries the highway is maintained by the state and signed with the MD 295 designation. This section of the parkway passes near Baltimore–Washington International Thurgood Marshall Airport.

Maryland Route 295

Baltimore–Washington Parkway
MD 295 highlighted in red
Route information
Maintained by NPS, MDSHA, Baltimore DOT
Length32.52 mi (52.34 km)
Existed1950–present
Tourist
routes
Star-Spangled Banner Scenic Byway
RestrictionsNo commercial vehicles south of MD 175
Major junctions
South end US 50 / MD 201 in Cheverly
Major intersections
North end US 40 / MD 129 in Baltimore
Location
CountryUnited States
StateMaryland
CountiesPrince George's, Anne Arundel, Baltimore, City of Baltimore
Highway system
  • Maryland highway system
  • Interstate
  • US
  • State
  • Scenic Byways
I-295 MD 297

Upon entering Baltimore, the Baltimore Department of Transportation takes over maintenance of the road and it continues north to an interchange with Interstate 95 (I-95). Here, the Baltimore–Washington Parkway ends and MD 295 continues north unsigned on Russell Street, which carries the route north into downtown Baltimore. In downtown Baltimore, MD 295 follows Paca Street northbound and Greene Street southbound before ending at US 40.

Plans for a parkway linking Baltimore and Washington date back to Pierre Charles L'Enfant's original layout for Washington, D.C. in the 18th century but did not fully develop until the 1920s. Major reasons surrounding the need for a parkway included high accident rates on adjacent US 1 and defense purposes before World War II. In the mid-1940s, plans for the design of the parkway were finalized and construction began in 1947 for the state-maintained portion and in 1950 for the NPS-maintained segment. The entire parkway opened to traffic in stages between 1950 and 1954.

Following completion of the B–W Parkway, suburban growth took place in both Washington, D.C. and Baltimore. In the 1960s and the 1970s, there were plans to give the segment of the parkway owned by the NPS to the state and make it a part of I-295 and possibly I-95; however, they never came through and the entire road is today designated as MD 295, despite only being signed on the state-maintained portion. Between the 1980s and the 2000s, the NPS portion of the road was modernized. MD 295 is in the process of being widened from four to six lanes, with more widening and a new interchange along this segment planned for the future.

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.